Avaya J100 Series - Page 115

Name Description
WEP Key 3 Specifies the WEP key values for the Wi-Fi network.
The valid value is up to 26 alphanumeric characters that can be
the following:
• Blank
• 0 – 9
• A – F
The value must include 10 hexadecimal digits for 64 bit keys
and 26 hexadecimal digits for 128 bit keys. The default value is
empty.
WEP Key 4 Specifies the WEP key values for the Wi-Fi network.
The valid value is up to 26 alphanumeric characters that can be
the following:
• Blank
• 0 – 9
• A – F
The value must include 10 hexadecimal digits for 64 bit keys
and 26 hexadecimal digits for 128 bit keys. The default value is
empty.
WPA2 Enterprise (802.1x)
EAP Authentication Method Specifies the type of EAP authentication method.
The options are:
• PEAP (default)
• TLS
EAP Phase 2 Authentication Method Specifies the type of EAP Phase 2 authentication method.
The options are:
• None (default)
• MSCHAPV2
Authentication Identity Specifies the authentication identity.
The valid value is a string of up to 32 alphanumeric characters
and special symbols. The default value is blank.
Note:
The space character (ASCII 0x20) is not supported.
Table continues…
Configuring the phone using the web interface
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 115
Comments on this document? infodev@avaya.com