Avaya J100 Series - Page 246

BLA configuration
BLA configuration is done through the46xxsettings.txt file and web interface under Shared
Line Configuration. It is not recommended to manually change these settings. You can get the
required settings for this feature using DES Provisioning server. RingCentral server automatically
creates configuration files and adds MAC address of the phone to the RingCentral system.
The following settings are recommended for Ring Central Server:
•
SET SHARED_LINE_MODE 1
•
SET SCA_LINE_SEIZE_DURATION 360
•
SET OUTBOUND_SUBSCRIPTION_REQUEST_DURATION 360
•
SET REGISTERWAIT 300
• Configure the SOFTKEY_ACTIVE parameter for Call Park.
Shared Lines parameters
Use the 46xxsettings.txt file to set the following parameters:
Parameter Default
value
Description
SHARED_LINE_MOD
E
0 Specifies whether the Bridged Line Appearance (BLA) or Shared
Call Appearance (SCA) mode is used.
Value operation:
• 0: Indicates Shared Call Appearance mode.
• 1: Indicates Bridged Line Appearance mode.
PRIMARY_LINE_TYP
E
0 Specifies whether the phone’s primary line is a private or shared
line. If the primary line is a shared line, other settings that control
the primary line behavior are not affected.
Value operation:
• 0: Indicates a private line.
• 1: Indicates a shared line.
PRIMARY_LINE_BAR
GE_IN_ENABLED
1 Specifies whether the Barge-in soft key is displayed on the
primary line if there is a call on this line on another device.
Value operation:
• 0: Indicates Barge-in is disabled for the primary line.
• 1: Indicates Barge-in is enabled for the primary line.
This parameter is ignored in BLA mode.
Note:
Ring Central Server does not support Barge-in . This
parameter value is ignored if the selected line mode is BLA.
Table continues…
Feature and application configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 246
Comments on this document? infodev@avaya.com