Avaya J100 Series - Page 266

Parameter Type Default
value
Description
MYCERTWAIT Numeric 1 Specifies the functions of the device when performing
certificate enrolment. The options are:
• 0: Periodical check in the background
• 1: Wait until a certificate or a denial is received or a
pending notification is received
MYCERTCAID String CAIdenti
fier
Specifies the Certificate Authority Identifier. Certificate
Authority servers might require a specific CA Identifier
string to accept GetCA requests. If the device works with
such a Certificate Authority, the CA identifier string can
be set through this parameter.
SCEPPASSWORD String $SERIA
LNO
Specifies a challenge password to use with SCEP. The
value of SCEPPASSWORD, if non-null, is included in a
challengePassword attribute in SCEP certificate signing
requests.
If the value contains $SERIALNO, $SERIALNO is
replaced by the value of SERIALNO. If the value contains
$MACADDR, $MACADDR is replaced by the value of
MACADDR without the colon separators.
Security configurations
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 266
Comments on this document? infodev@avaya.com