Avaya J100 Series - Page 277

Parameter name Default value Required settings
SIPREGPROXYPOLICY simultaneous This must be set to alternate.
SIP_CONTROLLERS_LIST_2 Null This parameter should not be set
and left at default.
Open SIP redundancy does not
support IPv6.
3PCC_SERVER_MODE 0 This parameter should not be set
and should be left at default.
SIP_CONTROLLER_LIST Null This parameter must be
configured to provide redundant
sip servers for the phone to
connect to.
It must contain only 2 entries of
the following format.
host1[:port1]
[;transport1=xxx];
host2[:port2]
[;transport2=xxx]
Host can be an IPV4 address or
FQDN. Host cannot be IPV6
address.
Port and transport values are
optional. However, if these values
are known, provide them in the
settings.
An example setting:
SIP_CONTROLLER_LIST =
proxy1.sample.com:tcp:
5060;10.10.10.10:tcp:5060
Note:
When
SIP_CONTROLLER_LIST
contains FQDN, phone uses
DNS to resolve the FQDN
into IP addresses. If an
FQDN resolves to multiple IP
addresses, phone uses the
first resolved entry.
Set the following parameter when using UDP protocol:
SIP server redundancy
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 277
Comments on this document? infodev@avaya.com