Avaya J100 Series - Chapter 2: Making Calls; Making a Call

2. Place the expansion module bracket on one level to the right of the phone bracket, mark
and drill holes, and then affix the #8 screws.
3. To attach the Avaya J100 Expansion Module to the wall mount bracket, insert the upper tab
of the bracket into the slot on the back panel of the expansion module.
4. Attach the phone to the wall mount bracket.
Hardware installation
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 29
Comments on this document? infodev@avaya.com