Parameter name Default value Description
AUTO_SELECT_ANY_IDLE_APPR 0 Specifies that any idle call
appearance (primary or
bridged) can be
automatically selected.
This parameter works
along with the parameter
CONF_TRANS_ON_PRIM
ARY_APPR.
Value operation:
• 0: Disabled. Both
parameters
AUTO_SELECT_ANY_I
DLE_APPR and
AUTO_SELECT_ANY_I
DLE_APPR are set to 0.
• 1: Enabled. The
parameter
CONF_TRANS_ON_PRI
MARY_APPR is set to 0.
Note:
Avaya J129 IP Phone
does not support this
feature.
AWAY_TIMER 1 Specifies whether the
phone must report an
away state.
Value operation:
• 0: Disabled.
• 1: Enabled.
AWAY_TIMER_VALUE 30 Specifies the number of
minutes of idle time after
which the phone assumes
that the user is away from
the phone.
Valid values are from 1 to
1500 minutes.
B
Table continues…
List of configuration parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 301
Comments on this document? infodev@avaya.com
To Next Page
Loading...
