Avaya J100 Series - Page 300

Parameter name Default value Description
AUTHCTRLSTAT 0 Specifies that the
enhanced debugging
capabilities are activated
from an SSH server by an
AVAYA engineer.
Value operation:
• 0: Enhanced debugging
capabilities are disabled.
• 1: Enhanced debugging
capabilities are enabled.
Note:
The parameter must
be set to 1 only for
the debugging period.
Set the parameter
back to 0 when
debugging is
complete.
AUTO_ANSWER_DURING_CALL 0 Specifies auto-answer
calls during another active
call.
Value operation:
• 0: Do not auto-answer
when there is an active
call
• 1: Auto-answer when
there is an active call
Note:
Avaya J129 IP Phone
does not supports
this feature.
AUTO_ANSWER_MUTE_ENABLE 1 Specifies the status of the
mute function for the auto-
answered calls.
Value operation:
• 0: Disabled
• 1: Enabled
Table continues…
Customizable parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 300
Comments on this document? infodev@avaya.com