Avaya J100 Series - Page 454

Parameter name Default value Description
SLMCAP 0 Specifies if the SLA
Monitor agent is enabled
for packet capture.
Value operation:
• 0: Disabled (default)
• 1: Enabled and payloads
are removed from RTP
packets
• 2: Enabled and payloads
are included in RTP
packets
• 3: Controlled from admin
menu - Allows you to
enable or disable of RTP
packets capture using
local admin procedures.
SLMCTRL 0 Specifies whether the SLA
Monitor agent is enabled
for phone control.
Value operation:
• 0: Disabled
• 1: Enabled
• 2: Controlled from admin
menu.
SLMPERF 1 Specifies whether the SLA
Monitor agent is enabled
for phone performance
monitoring.
Value operation:
0: Disabled (default)
1: Enabled
Table continues…
Customizable parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 454
Comments on this document? infodev@avaya.com