Avaya J100 Series - Page 455

Parameter name Default value Description
SLMPORT 50,011 Specifies the UDP port
that will be opened by the
SLA Monitor agent to
receive discovery and test
request messages.
Valid values are 6,000
through 65,535. The
default value is 50,011.
Note:
If default port is not
used, both the SLA
Mon agent and the
server must be
configured with the
same port. This
parameter impacts
the phone's SLA Mon
agent configuration.
A corresponding
configuration must
also be made on the
SLA Mon server
agentcom-
slamon.conf file.
Table continues…
List of configuration parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 455
Comments on this document? infodev@avaya.com