Avaya J100 Series - Page 473

Parameter name Default value Description
USBPOWER 2 Controls USB power when
power is provided to the
USB interface.
Value operation:
• 0: Turn off USB power
regardless of power
source.
• 1: Turn on USB power
only if Aux powered.
• 2: Turn on USB power
regardless of power
source.
• 3: Turn on USB power if
Aux powered or PoE
Class 3 power.
Note:
This parameter is
supported only in
Avaya J159 IP Phone
USE_CONTACT_IN_REFERTO 1 Specifies which transfer
target address should be
used in Refer-To a header
of REFER SIP request on
attended transfer.
Value operation:
• 0: Use CONTACT URI of
the transfer target in
Refer-To header of
REFER SIP request.
• 1: Use TO URI of the
transfer target in Refer-
To header of REFER
SIP request.
Table continues…
List of configuration parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 473
Comments on this document? infodev@avaya.com