Avaya J100 Series - Page 491

PHONEKEY
setting
Allowed
valuesname
Definition Additional parameters
blf Busy Lamp Field** Specify the following:
• Attr1 : user ID or BLF ID
• Attr2 : destination extension
SET PHONEKEY
"Key=1;Type=feature;Name=blf;attr1=b
lf2065852005;attr2=88053"
The PHONEKEY syntax depends on the
BLF mode.
If Attr2 is defined for BLF, and label is
not defined, the Attr2 is used as the
default label for BLF.
If Attr1 is defined for BLF, Attr2 and
label are not defined, the Attr1 is used
as the default label for BLF.
If Attr2 is a null value, then Attr1 is the
destination extension.
Note:
The number of configured BLF lines
must not exceed the total number of
the phone lines.
Both Attr1 and Attr2 are used only
in the RingCentral environment.
blfpark Shared Parking Specify the shared phone extension as
attr1:
SET PHONEKEY
"Key=5;Type=feature;Name=blfpark;att
r1=SP1"
broadworks-call-
center
Broadworks Call
Center*
Activate the view
providing Call
Center features
bw-cc-dispcode Disposition Code*
Activate the view to
select a disposition
code
Table continues…
PHONEKEY parameter values
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 491
Comments on this document? infodev@avaya.com