EasyManua.ls Logo

Avaya J100 Series - Page 55

Avaya J100 Series
528 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Code Parameter
11 PHY1STAT
12 PHY2STAT
14 SIG
15 SIP_CONTROLLER_LIST
Extending use of DHCP lease
Avaya J100 Series IP Phones support configuration of network parameters using DHCP as per
RFC 2131. However, when a DHCP server becomes unreachable and the DHCP lease currently
held by the phone expires, the phone continues to use the same lease until the DHCP server
becomes reachable. This functionality is controlled by setting the following parameter:
Parameter name Default value Description
DHCPSTD 0 Specifies if the expired DHCP lease is used.
Value operation:
0: Continue use of the expired DHCP lease if
the lease could not be renewed.
1: Stop using the DHCP lease immediately
when it expires, as per the standard.
The parameter is configured through the
46xxsettings.txt file.
When this feature is enabled (DHCPSTD=1), the phone continues to use the lease data, including
IP address, router and other options if the lease could not be renewed. In this state, the phone will
attempt to reach a DHCP server every 60 seconds. When a DHCP server becomes available and
a lease is renewed or new lease obtained, the phone performs a duplicate address detection on
the offered IP address. If no conflicts are detected, this IP address is assigned to the local network
interface for use.
Parameter configuration through DHCP
Avaya J100 Series IP Phones support the DHCP configuration option called Site Specific Option
(SSON). Using this option, custom parameters can be configured on the phone through a DHCP
server. In DHCP DISCOVER, the phone requests for the SSON, typically configured in DHCP
Option 242. To respond to this request, configure the DHCP server with proper data supplied in
the offer for this option value. The following is an example of such configuration:
option avaya-option-242 L2Q=1,L2QVLAN=1212,httpsrvr=192.168.0.100
The following parameters can be configured with this feature:
Parameter Set to
DHCP lease
time
Option 51, if received
Table continues…
Configuration through DHCP
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 55
Comments on this document? infodev@avaya.com

Table of Contents

Other manuals for Avaya J100 Series

Related product manuals