Baumer VCXG Series - Balancewhiteautostatus; Brightnessautonominalvalue; Brightnessautopriority

V4.7 | 06/24/2024 | 11165414
91
7.3.8 BalanceWhiteAutoStatus
Status of BalanceWhiteAuto.
Name AutoFeatureRegionSelector
Category AutoFeatureControl
Interface IEnumeration
Access Read only
Unit -
Values
ColorGains-
TooHigh
The BalanceWhiteAuto calculation failed since at least
one of the calculated color gains exceeds the maximum
value.
Initial BalanceWhiteAuto has never been started.
Start BalanceWhiteAuto is waiting for statistic data.
Success The last BalanceWhiteAuto calculation succeeded.
Underrun
The BalanceWhiteAuto calculation failed since at least
one color-channel shows invalid statistic data.
7.3.9 BrightnessAutoNominalValue
Sets the nominal value for brightness in percent of full scale. It will be adjust with consider
the setting in BrightnessAutoPriority.
Name BrightnessAutoNominalValue
Category AutoFeatureControl
Interface IFloat
Access Read / Write
Unit %
Values 5 - 95 (Increment: 1)
7.3.10 BrightnessAutoPriority
The feature set the highest priority auto feature to adjust the brightness.
Notice
When BrightnessAutoPriority is set to GainAuto, the brightening of the image is rst
achieved by increasing the gain. This can cause image noise, but the frame rate is not
reduced.
Name BrightnessAutoPriority
Category AutoFeatureControl
Interface IEnumeration
Access Read / Write
Unit -
Values
ExposureAuto
ExposureAuto has highest priority and will be modied
rst.
GainAuto GainAuto has highest priority and will be modied rst.