Chapter 2: BD FACSDiva Software Overview 43
To copy and paste a specimen:
1 Click the specimen in the List of specimens on the plate. Right-click a well
in that specimen, then select Copy.
2 Select an empty well, then right-click it and select Paste.
The specimen will be pasted, if there is room on the plate.
Setup View Functions
Use the Setup view to set up new plate-based experiments. Once you have added
setup controls, samples, and cytometer settings to the plate layout, you can assign
keywords, set recording rules, apply a selected assay (Analysis template), and
copy and paste HTS (loader) settings to selected wells or to the entire plate.
Use the Setup view to perform the following functions:
• Define loader settings
• Optimize cytometer settings while running setup controls
• Monitor well status during acquisition
• Acquire and record wells manually or automatically
• Analyze plate data
To Next Page
