143
20/03/06 3.2.0 Correction of Run Time errors
Improve the Base Line execution (repetion when it fails)
26/06/06 3.2.2 New button in the tools menu, reset the historical base line
Fix the options of the initial and final wash. Delete the menu to
choose the parameter of initial and final wash.
Change in the versions of firmware
Date version Change
21/05/03 1.0 First version
9/06/03 1.3 Correction of washing cycles. Correction of Base line. Correction of
communications.
25/07/03 1.34 Improve of switch on/off of the analyser. Robust rotor manoeuvre.
1/12/03 1.40 Improve the communications of auxiliar channel. Improve the stress
mode. Correction of integration time calculus.
13/02/04 1.60 Improve the information send by the auxiliar channel. Improve the
switch off lamp. Correction of the temperature rotor and probe con-
trol.
9/07/04 2.00 Improve and robust the communications. New implementation of the
turbidimetric system. New functional of the alarm acustic signal.
Correction, unification of the criterions of service and user
programs. Improve the stress mode. Add the sensibility map of the
racks.
23/07/04 2.02 Corrections of the level deteccion map.
28/02/05 2.40 Improve the demo test. Improve the bireactive test with
contaminations. Enlarge the integration time limits. Improve the
encoder control.
4/03/05 2.42
14/03/05 2.44 Corretion of the synthesis of FPGA
17/05/05 2.46 Add 2 new type of racks of 13 and 15mm. Correction of stress test.
31/05/05 2.48 Correction of encoder control
14/09/05 2.50 Impove, from user program load the analyser adjustments.
03/02/06 2.54 Correction of the encoder error during warming-up and shut-down
20/03/06 2.80 Improve the execution of base line
new adjustment, the maximum sweep of the z axis
New cycles meter
Correct the bireactive, bichromatic with contamination test
26/05/06 2.94 Increase the acceptance range of base line check
Increase the Z motor current to 1.6A
To Next Page
Loading...
Need help?
General