Required Steps to Follow
HCS01 drive controllers were designed for control cabinet mounting. They
are mounted with two screws (M6×20; contained in the supplied accesso‐
ry HAS09).
Mounting the drive controller
1. Fix screws to the back panel of the control cabinet.
2. Attach the drive controller to the screws.
3. Fix the screws with 6 Nm.
Bosch Rexroth AG DOK-INDRV*-HCS01******-PR05-EN-P122/341
Rexroth IndraDrive CsDrive Systems with HCS01
Mounting and installation
To Next Page
Loading...
Need help?
General