Ground connection
The ground connection of the housing is used to provide functional safety of
the drive controllers and protection against contact in conjunction with the
equipment grounding conductor.
Ground the housings of the drive controllers:
1. Connect the bare metal back panel of the drive controller in conductive
form to the mounting surface in the control cabinet. To do this, use the
supplied mounting screws.
2. Connect the mounting surface of the control cabinet in conductive form
to the equipment grounding system.
3. For the ground connection, observe the maximum allowed ground re‐
sistance.
Bosch Rexroth AG DOK-INDRV*-HCS01******-PR05-EN-P158/341
Rexroth IndraDrive CsDrive Systems with HCS01
Mounting and installation
To Next Page
Loading...
Need help?
General