5-3
Confidential
(2) Press the Black Start (Mono Start) key on the control panel. Next press the Scan key four
times.
The machine beeps for approx. one second and displays " " and
the numerical keypad on the touch panel, indicating that it is placed in the initial stage of
the maintenance mode, a mode in which the machine is ready to accept entry from the keys.
(3) To select one of the maintenance-mode functions listed in Section 5.1.3, enter the
corresponding 2-digit function code with the numerical keys. (The details of each
maintenance-mode function are described in Section 5.1.4.)
TIP: Models with numerical keypad on the control panel can enter the maintenance mode
in the same way as conventional models; that is, by pressing the Menu (or Scan and Copy
keys simultaneously), *, 2, 8, 6 and 4 keys in this order.
NOTES:• To exit from the maintenance mode and switch to standby, press the 9
key twice
in the initial stage of the maintenance mode.
• Pressing the Stop/Exit key after entering only one digit restores the machine to
the initial stage of the maintenance mode.
• If an invalid function code is entered, the machine resumes the initial stage of
the maintenance mode.
• Pressing the Scan and Copy keys simultaneously switches the software keypad
on the touch panel between the numerical and function keypads.
• In some functions (e.g., adjustment of touch panel with Function code 78 in Section
5.1.4.29), the software keypad is not available.
• In the maintenance mode, the functions listed below are assigned to the keys on the
control panel.
Pressing the Scan or Copy key several times scrolls the display to find a desired function
on the touch panel and pressing the PHOTO CAPTURE key selects the function.
Keys on the control panel Functions assigned
Scan key
Copy key
PHOTO CAPTURE key OK
To Next Page
Loading...
