Brother MFC-J6510DW

2-18
Confidential
*1 Available in German models only.
*2 Establishment of FAX communication
FAX communication is established when the calling station receives a DIS (reception capability) signal
from the called station and the called station receives an NSS or DCS (communications test) signal from
the calling station.
Code 1 Code 2 Cause Refer to:
A0 03 Error correction sequence not terminated even at the
final transmission speed for fallback.
Section 2.4.9.7
A0 11 Receive buffer empty. (5-second time-out)
A0 12 Receive buffer full during operation except receiving
into memory.
A0 13 Decoding error continued on 500 lines.
A0 14 Decoding error continued for 10 seconds.
A0 15 Time-out: 13 seconds or more for one-line
transmission.
A0 16 RTC not found and carrier OFF signal detected for 6
seconds.
A0 17 RTC found but no command detected for 60 seconds.
A0 19 Receive buffer full during receiving into memory.
A8 01 RTN, PIN, or ERR received at the calling terminal.
*1
A9 01 RTN, PIN, or ERR received at the called terminal.
*1
AA 18 Receive buffer full during receiving into memory.
B0 02 Unable to receive the next-page data.
B0 03 Unable to receive polling even during turn-around
transmission due to call reservation.
B0 04 PC interface error.
BF 01 Communication canceled by pressing the STOP key
before establishment of FAX communication
*2
.
BF 02 Communication canceled by pressing the STOP key
after establishment of FAX communication
*2
.
BF 03 Transmission canceled due to a scanning error caused
by no document or document feed problem in ADF
scanning in real time transmission.