Brother MFC-J6510DW

2-37
Confidential
 Error Code 44
Abnormal temperature of the print head driver.
 Error Code 46
Purge count or flushing count overflown.
*
For the resetting procedures of the flushing count, refer to Chapter 4, Section 4.4.
 Error Code 48
Head flat cables halfway connected.
Unable to Print 44
LCD
Step Cause Solution
1 Connection failure of the carriage-
head flat cable or head flat cables
Check the connection and reconnect the
corresponding flat cable(s).
2
Head property data not entered Enter the head property data.
3
Print head defective Replace the head/carriage unit.
4
Main PCB defective
Replace the main PCB ASSY.
Unable to Print 46
LCD
Ink Absorber Full
Step Cause Solution
1
Ink absorber box and flushing box
full of ink
Replace the ink absorber box and flushing box, then
reset their counts. *
Unable to Init. 48
LCD
Step Cause Solution
1 Connection failure of the carriage-
head flat cable or head flat cables
Check the connection and reconnect the
corresponding flat cable(s).
2
Print head defective Replace the head/carriage unit.
3
Main PCB defective
Replace the main PCB ASSY.