BRP ROTAX 916 i A Series - Page 190

BRP-Rotax
INSTALLATION MANUAL
m WARNING
Non-compliance can result in serious injuries or death!
The vacuum must be verified over the complete engine operation range. If the oil is
cold, the flow resistance increases, which means that not enough oil will flow on the
suction side.
Oil tank installa-
tion positions
Oil tank
System Limit
Min. Max.
Angular deviation
- 10° + 10°
Tank position in relation to
engine
+40 mm (+1.57 in.) –360 mm (-14.17 in.)
Figure 12.4: Oil tank installation position, TYPICAL
The oil tank must be installed on a low-vibration position and not on the engine directly.
The oil tank cover and the oil drain screw must be easily accessible.
NOTE
The oil tank has to positioned on its z-axis such that the normal oil level is always
between 0 and –360 mm (-14.17 in.) on the z-axis.
79–00–00
Page 6
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1