Appendix B: Wiring B-3
HOME
AMP MULTILOCK B.2
GENERAL
Amp Multilock connectors are found in 3-place, 6-place and
10-place versions though not all terminal cavities may be
used. Amp Multilock connectors are found between wire har-
nesses and component wiring and may be either floating or
anchored to the frame with attachment clips.
See Figure B-1. Attachment clips (1) on the pin housings are
fitted to T-studs on the motorcycle frame. The T-studs identify
OE connector locations. To maintain serviceability, always
return connectors to OE locations after service.
NOTE
A TERMINAL REPAIR KIT (HD-39621-A) contains a variety
of replacement Amp terminals and the pin and socket tools.
For terminal crimping use the PACKARD TERMINAL
CRIMPER (HD-38125-7).
PIN AND SOCKET HOUSINGS
Separate Housings
1. If necessary, slide connector with attachment clip rear-
ward to release it from the T-stud.
2. See Figure B-1. Depress the release button (2) on the
socket terminal side of the connector and pull the socket
housing (plug) (3) out of the pin housing (receptacle) (4).
Mate Housings
1. Hold the housings to match wire color to wire color.
2. Insert the socket housing into the pin housing until it
snaps in place.
3. If OE location is a T-stud, fit large opening end of attach-
ment clip over T-stud and slide connector forward to
engage T-stud to small end of opening.
PART NO. SPECIALTY TOOL
HD-39621-A Terminal repair kits
HD-41609 Amp Multi-lock crimper
HD-39621-28 Pin terminal tool
HD-39621-27 Socket terminal tool
Figure B-1. Amp Multilock Connector]
1. Attachment clip
2. Release button
3. Socket housing
4. Pin housing
12433
3
1
1
2
To Next Page
Loading...
