Buell P3 - Page 194

2007 Buell P3: Engine 3-11
HOME
NOTE
See Figure 3-9. Remove rear master cylinder before remov-
ing sprocket cover.
22. Remove sprocket cover. See 2.22 SPROCKET COVER.
23. See Figure 3-9. Disconnect screws (1, 3, 6) at brake fluid
reservoir, master cylinder and brake line bracket.
24. Move belt on rear sprocket off pulley toward inside of
motorcycle.
25. See Figure 3-10. Remove right side rider footpeg bracket
assembly. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
26. Introduce freeplay and remove clutch cable at hand lever
location. See 1.9 CLUTCH.
27. Refer to Table 3-19. Disconnect the following electrical
items.
Figure 3-9. Rear Master Cylinder and
Brake Line Assembly
1. Screw
2. Brake fluid reservoir
3. Screw
4. Brake line bracket
5. Brake line
6. Screw
7. Master cylinder
8. Spacer
1
3
6
7
8
2
5
4
a0017x3x
Figure 3-10. Footpeg Bracket Assembly
1. Frame
2. Locknut
3. Washer
4. Spacer
5. Footrest support bracket
6. Clevis pin
7. Footpeg
8. Cotter pin
9. Index plate
10. Spacer
a0016x3x
1
2
3
4
5
6
8
7
10
9