31
Section 3. Initial Inspection
• The CR800 datalogger ship with,
o 1 each pn 8125 small, flat-bladed screwdriver
o 1 each pn 1113 large, flat-bladed screwdriver
o 1 each pn 3315 five-inch long, type-T thermocouple for use as a tutorial
device
o One datalogger program pre-loaded into the CR800
o 4 each pn 505 screws for use in mounting the CR800 to an enclosure
backplate.
o 4 each pn 6044 nylon hardware inserts for use in mounting the CR800 to
a Campbell Scientific enclosure backplate.
o 1 each pn 10873, six-foot, nine-pin female to nine-pin male serial cable
for use in connecting the CR800 to the serial port of a PC.
o ResourceDVD, which contains product manuals and the following starter
software:
Short Cut
PC200W
Devconfig
• Upon receipt of the CR800, inspect the packaging and contents for damage.
File damage claims with the shipping company.
• Immediately check package contents. Thoroughly check all packaging
material for product that may be concealed. Check model number, part
numbers, and product descriptions against the shipping documents. Model or
part numbers are found on each product. On cables, the number is often
found at the end of the cable that connects to the measurement device.
Ensure that the expected lengths of cables were received. Contact Campbell
Scientific immediately if there are any discrepancies.
To Next Page
Loading...
Need help?
General
