Campbell CR850 - 465; Specific Sensors

Appendix A. CRBasic Programming Instructions
465
A.5.8 SDI-12
Read More! See SDI-12 Sensor Support (p. 173).
SDI12Recorder
RetrievestheresultsfromanSDI‐12sensor.
Syntax
SDI12Recorder(Dest, SDIPort, SDIAddress, SDICommand,
Multiplier, Offset)
SDI12SensorSetup
SetsupthedataloggertoactasanSDI‐12sensor

SDI12SensorResponse
HoldsthesourceofthedatatosendtotheSDI‐12recorder.
Syntax
SDI12SensorSetup(Repetitions, SDIPort, SDIAddress,
ResponseTime)
SDI12SensorResponse(SDI12Source)
A.5.9 Specific Sensors
ACPower
Measuresrealacpowerandpower‐qualityparametersforsingle‐,split‐,and
three‐phase'Y'configurations.
Syntax
ACPower(DestAC, ConfigAC, LineFrq, ChanV, VMult, MaxVrms,
ChanI, IMult, MaxIrms, Reps)
DANGER ac power can kill. User is responsible for ensuring connections to ac
power mains conforms to applicable electrical codes. Contact a Campbell
Scientific applications engineer for information on available isolation
transformers.
CS110
MeasureselectricfieldbymeansofaCS110electric‐fieldmeter.
Syntax
CS110(Dest, Leakage, Status, Integ, Mult, Offset)
CS110Shutter
ControlstheshutterofaCS110electric‐fieldmeter.
Syntax
CS110Shutter(Status, Move)
CS616
EnablesandmeasuresaCS616watercontentreflectometer.
Syntax
CS616(Dest, Reps, SEChan, Port, MeasPerPort, Mult, Offset)