Campbell CR850 User Manual

Appendix A. CRBasic Programming Instructions
468


A.5.10 Peripheral Device Support
Multiple SDM instructions can be used within a program.
AM25T
ControlstheAM25TMultiplexer.
Syntax
AM25T(Dest, Reps, Range, AM25TChan, DiffChan, TCType, Tref,
ClkPort, ResPort, VxChan, RevDiff, SettlingTime, Integ,
Mult, Offset)
AVW200
EnablesCR800togetmeasurementsfromanAVW200VibratingWireSpectrum
Analyzer.
Syntax
AVW200(Result, ComPort, NeighborAddr, PakBusAddr, Dest,
AVWChan, MuxChan, Reps, BeginFreq, EndFreq, ExVolt,
Therm50_60Hz, Multiplier, Offset)
CDM_VW300Config
ConfigurestheCDM_VW300DynamicVibratingWireModule.
Syntax
CDM_VW300Config(DeviceType, CPIAddress, SysOptions,
ChanEnable, ResonAmp, LowFreq, HighFreq, ChanOptions,
Mult, Offset, SteinA, SteinB, SteinC, RF_MeanBins,
RF_AmpBins, RF_LowLim, RF_HighLim, RF_Hyst, RF_Form)
CDM_VW300Dynamic
Capturesdynamicvibrating‐wiresensorreadingsfromtheCDM_VW300.
Syntax
CDM_VW300Dynamic(CPIAddress, DestFreq, DestDiag)
CDM_VW300Rainflow
ObtainsrainflowhistogramdatafromtheCDM_VW300.
Syntax
CDM_VW300Rainflow(CPIAddress, RF1, RF2, RF3, RF4, RF5, RF6,
RF7, RF8)
CDM_VW300Static
Capturesstaticvibrating‐wiresensorreadingsfromtheCDM_VW300.
Syntax
CDM_VW300Static(CPIAddress, DestFreq, DestTherm, DestStdDev)
CPISpeed
ControlsthespeedoftheCPIbus.
Syntax
CPISpeed(BitRate))
MuxSelect
Selectsthespecifiedchannelonamultiplexer.
Syntax
MuxSelect(ClkPort, ResPort, ClkPulseWidth, MuxChan, Mode)

Campbell CR850 Specifications

General

Brand	Campbell
Model	CR850
Category	Measuring Instruments
Language	English