Canon imagePROGRAF iPF755 User Guide

HP-GL/2 problems
With HP-GL/2, printing is misaligned .............................................................................................................. 867
Lines or images are missing in printed HP-GL/2 jobs. ................................................................................... 867
Lines are printed too thick or thin in HP-GL/2 print jobs ................................................................................. 867
HP-GL/2 jobs are printed in monochrome (or color) ...................................................................................... 867
Printed colors of lines are inaccurate during HP-GL/2 printing ...................................................................... 868
HP-GL/2 jobs are printed 6 mm larger than specified .................................................................................... 868
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified .......................................... 868
HP-GL/2 printing takes a long time ................................................................................................................. 868
The printer stops when printing a HP-GL/2 job (the carriage stops moving) ................................................. 868
With HP-GL/2, printing is misaligned
Cause Corrective Action
The plotter origin is incorrect. Check the printing commands.
The Margin setting in the Control Panel menu is incor-
rect.
Adjust the Margin setting values in the Control Panel
menu.
Lines or images are missing in printed HP-GL/2 jobs.
Cause Corrective Action
The memory is full. Check the size of the data in the print job.
An HP-GL/2 command not supported by this printer was re-
ceived.
Check the print job and settings.
The printer has received print data that includes HP RTL com-
mands when Auto Rotate is On in the Control Panel menu.
In the Control Panel, set Auto Rotate to Off and
print again.
(See "Menu Settings.") →P.738
Lines are printed too thick or thin in HP-GL/2 print jobs
Cause Corrective Action
The Width setting in the
Control Panel menu is in-
correct.
Check the Width setting value specified for Pen no. in Palette A or Palette B in the
Control Panel menu. If fine lines are printed faintly, setting ThickenFineLines to On
will print the lines more distinctly.
(See "Menu Settings.") →P.738
HP-GL/2 jobs are printed in monochrome (or color)
Cause
Corrective Action
The Color Mode setting in
the Control Panel menu is in-
correct.
Check the Color Mode setting in the Control Panel menu.
(See "Menu Settings.") →P.738
However, for optimal Printhead performance, the printer consumes trace amounts of
color ink even when Monochrome is selected as Color Mode.
Troubleshooting > HP-GL/2 problems >
iPF755 With HP-GL/2, printing is misaligned
12
867
Downloaded from ManualsPrinter.com Manuals

Canon imagePROGRAF iPF755 Specifications

General

Printer Type	Large Format Printer
Maximum Print Resolution	2400 x 1200 dpi
Number of Ink Colors	5
Number of Nozzles	15, 360
Memory (Standard)	256 MB
Hard Drive	80 GB
Ink Droplet Size	4 picoliters
Operating Systems	Windows, Mac OS
Print Technology	Inkjet
Ink Type	Pigment/Dye
Maximum Print Width	36 inches
Connectivity	USB, Ethernet
Media Handling	Roll Feed
Media Width	8 inches to 36 inches
Media Thickness	0.07 - 0.8mm
Ink Colors	Cyan, Magenta, Yellow, Black
Media Sizes	Roll paper: 10"-36" (254mm-914mm), Cut sheet: 8"-36" (203.2mm-914mm)
Media Types	Plain Paper, Coated Paper, Photo Paper
Power Consumption	140W or less
Print Speed (Color)	D-sized print (33.1 x 23.4 inches) in approximately 28 seconds
Print Speed (Black & White)	D-sized print (33.1 x 23.4 inches) in approximately 28 seconds