Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
TARE (Enter): The TARE key is used during
normal operation to store the current Gross weight as
the new Tare weight. The display will change to the Net
weight and the Net annunciator will turn on.
During Setup, pressing the TARE key will
display the current setting of the parameter.
Pressing the TARE key a second time (after
changing parameter values or settings), signals
completion of the entry of data and causes the
indicator to process the data entered.
NET/GROSS: The NET/GROSS key is used to toggle
between the Gross and Net weight modes. The
selected mode is indicated by turning on the appropriate
annunciator on the display.
Note that if no valid tare weight has been entered,
pressing the NET/GROSS key will cause a momentary
display error (notArE) and the indicator will remain in
the Gross weight mode.
When in Hold, Count, Peak weight, Live weight, or
Accumulator display mode, press the NET/GROSS key
to return the display to normal weight display mode.
UNITS/ (Left Arrow): The UNITS/ key is used for
several functions.
In normal operation, the UNITS/ key is used to
select the units in which the weight is to be
displayed. The available units of measure ("unit1",
“unit2” and "unit3") are selected in setup. The
available units include pounds, ounces, kilograms,
and grams.
During setup, the UNITS/ key is used to advance the
cursor left to the next position when inputting setup
parameters.
To Next Page
Loading...
Need help?
General
