CS 7600_User Guide (8J4071)_Ed04 63
Disinfecting the Hygienic Sheath and the Imaging Plates
Frequency of Disinfection
The hygienic sheath is the primary means of infection control and protection from contaminated imaging
plates.
Disinfect the imaging plate after every use (after the image plate is scanned), before it is inserted in the
hygenic sheath for the next use.
Disinfection Solutions
To disinfect, use either a self-prepared solution, or a commercially prepared product that adheres to the
following specifications and restrictions:
• Diluted bleach solution: dilute one part 5.25% sodium hypochlorite with ten parts of water.
• A commercially prepared equivalent solution of diluted bleach that does not contain any
ingredients (Isopropyl alcohol, hydrogen peroxide and other peroxides, citrus-based cleaners, hand
lotions and water-less hand sanitizers, as well as surfactants and lubricants) that can cause damage
to the hygienic sheaths and imaging plates.
Disinfection Method
To disinfect the hygienic sheaths and imaging plates, follow these steps:
1 Moisten thoroughly (but not dripping) a non-abrasive, lint-free cloth with the prepared diluted bleach
and wipe the hygienic sheath clean.
2 After one minute wipe off the bleach residue with a new, soft, lint-free cloth dampened with water.
3 Wipe dry with a non-abrasive, lint-free cloth.
Disposing of the Imaging Plate
CAUTION: Do not soak the hygienic sheath in any cleaning or
disinfecting solutions. Do not autoclave; autoclaved hygienic sheaths must
be discarded.
CAUTION: If a commercially prepared equivalent solution of diluted
bleach is used, follow the manufacturer’s specifications and warnings.
Important: The imaging plate contains Barium and should be
considered hazardous or special waste in specific conditions at the end of
its useful service life. For disposal or recycling information, contact your
local authorities.
To Next Page
Loading...
