53-6
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 53 Managing SSMs and SSCs
Configuring the SSC Management Interface
• Click the Configure the IPS SSC module link.
Note If you want to change the SSC configuration settings at a later date, click the IPS tab.
Password Troubleshooting
You can reset the SSM/SSC password to the default; for IPS, password reset is supported if the SSM/SSC
is running IPS Version 6.0 or later. The default password is “cisco” (without the quotation marks). After
resetting the password, you should change it to a unique value using the SSM/SSC application.
Resetting the SSM/SSC password causes the SSM/SSC to reboot. Services are not available while the
SSM/SSC is rebooting.
After you log in and define a new password, you do not need to log in to the software again. If you cannot
connect to the software with the new password, restart ASDM and try to log in again.
If you defined a new password and still have an existing password that is different from the new
password, clear the password cache by choosing File > Clear ASDM Password Cache, then restart
ASDM and try to log in again.
Detailed Steps
Step 1 From the ASDM menu bar, choose Tools > IPS Password Reset or Tools > CSC Password Reset.
The IPS/CSC Password Reset confirmation dialog box appears.
Step 2 Click OK to reset the password to the default.
A dialog box displays the success or failure of the password reset.For IPS, if the password was not reset,
make sure you are using IPS Version 6.0 or later on the AIP SSM/SSC.
Step 3 Click Close to close the dialog box.
To Next Page
Loading...
Need help?
General
