55-10
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 55 Configuring the Content Security and Control Application on the CSC SSM
Monitoring the CSC SSM
Step 4 Click the Create a new traffic class option, type a name for the traffic class in the adjacent field, check
the Any traffic check box, and then click Next.
The Rule Actions screen appears.
Step 5 Click the CSC Scan tab, and then check the Enable CSC scan for this traffic flow check box.
Step 6 Choose whether the adaptive security appliance should permit or deny selected traffic to pass if the CSC
SSM is unavailable by making the applicable selection in the area labeled: If CSC card fails, then.
When this check box is checked, the other parameters on this tab become active.
Step 7 In the If CSC card fails area, if the CSC SSM becomes inoperable, choose one of the following actions:
• To allow traffic, check the Permit traffic check box.
• To block traffic, check the Close traffic check box.
Step 8 Click Finish.
The new service policy rule appears in the Service Policy Rules pane.
Step 9 Click Apply.
The adaptive security appliance begins diverting traffic to the CSC SSM, which performs the content
security scans that have been enabled according to the license that you purchased.
What to Do Next
See the “Monitoring the CSC SSM” section on page 55-10.
Monitoring the CSC SSM
ASDM lets you monitor the CSC SSM statistics as well as CSC SSM-related features.
Note If you have not completed the CSC Setup Wizard in Configuration > Trend Micro Content Security >
CSC Setup, you cannot access the panes under Monitoring > Trend Micro Content Security. Instead, a
dialog box appears and lets you access the CSC Setup Wizard directly from Monitoring > Trend Micro
Content Security.
This section includes the following topics:
• Threats, page 55-11
• Live Security Events, page 55-11
• Live Security Events Log, page 55-12
• Software Updates, page 55-13
• Resource Graphs, page 55-13
To Next Page
Loading...
Need help?
General
