74-3
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 74 Configuring Smart Call Home
Licensing Requirements for Smart Call Home
• The customer ID.
• The site ID.
• The contract ID.
In the Alert Control pane, administrators can fine tune alert control parameters. This pane includes the
Alert group status pane, which lists the status (enabled or disabled) of the following alert groups:
• The diagnostics alert group.
• The configuration alert group.
• The environmental alert group.
• The inventory alert group.
• The snapshot alert group.
• The syslog alert group.
• The telemetry alert group.
• The threat alert group.
• The maximum number of Smart Call Home messages processed per minute.
• The “from” e-mail address in Smart Call Home e-mail.
Step 4 Double-click Alert Subscription Profiles. Each named subscription profile identifies subscribers and
alert groups of interest.
a. Click Add or Edit to display the Subscription Profile Editor, in which you can create a new
subscription profile or edit an existing subscription profile.
b. Click Delete to remove the selected profile.
c. Check the Active check box to send the Smart Call Home message of the selected subscription
profile to subscribers.
Step 5 When you click Add or Edit, the Add or Edit Alert Subscription Profile dialog box appears.
a. The Name field is read-only, so you cannot edit it.
b. Check the Enable this subscription profile check box to enable or disable this particular profile.
c. Click either the HTTP or Email radio button in the Alert Delivery Method area.
d. In the Subscribers field, specify the alert delivery method: e-mail address or web address.
The Alert Dispatch area lets the administrator specify what type of Smart Call Home information to send to subscribers and
e. The Message Parameters area lets you fine tune parameters that control messages sent to the
subscriber, including the preferred message format and the maximum message size.
Step 6 For time-based alerts, in the Alert Dispatch area, click Add or Edit to display the Add or Edit
Configuration Alert Dispatch Condition dialog box.
a. In the Alert Dispatch Frequency area, specify the frequency in which to send the information to
subscribers:
• For monthly subscription, specify the day of the month, as well as the time of the day to send the
information. If they are not specified, the adaptive security appliance chooses appropriate values for
them.
• For weekly subscription, specify the day of the week, as well as the time of the day to send the
information. If they are not specified, the adaptive security appliance chooses appropriate values for
them.
• For daily subscription, specify the time of the day to send the information. If it is not specified, the
adaptive security appliance chooses an appropriate value for it.
To Next Page
Loading...
Need help?
General
