74-5
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 74 Configuring Smart Call Home
Smart Call Home Monitoring
–
For monthly subscription, specify the day of the month, as well as the time of the day to send
the information. If they are not specified, the adaptive security appliance chooses appropriate
values for them.
–
For weekly subscription, specify the day of the week, as well as the time of the day to send the
information. If they are not specified, the adaptive security appliance chooses appropriate
values for them.
–
For daily subscription, specify the time of the day to send the information. If it is not specified,
the adaptive security appliance chooses an appropriate value for it.
–
For hourly subscription, specify the minute of the hour to send the information. If it is not
specified, the adaptive security appliance chooses an appropriate value for it. Hourly
subscription is only applicable to the snapshot and telemetry alert groups.
b. Click OK when you are done.
Smart Call Home Monitoring
To monitor the Smart Call Home feature, perform the following steps:
Path Purpose
Tools > Command Line Interface
Type show call- home detail, then click Send.
Shows the current Smart Call Home detail configuration.
Tools > Command Line Interface
Type show call-home mail-server status, then click Send.
Shows the current mail server status.
Tools > Command Line Interface
Type show smart-call- home profile {profile name | all, then
click Send.
Shows the configuration of Smart Call Home profiles.
Tools > Command Line Interface
Type show call-home registered-module all, then click
Send.
Shows the registered module status.
Tools > Command Line Interface
Type show smart-call statistics, then click Send.
Shows call-home detail status.
Tools > Command Line Interface
Type show call-home, then click Send.
Shows the current Smart Call Home configuration.
Tools > Command Line Interface
Type show dynamic-filter reports top, then click Send.
Generates reports of the top ten botnet sites, ports, and infected
hosts.
Tools > Command Line Interface
Type show dynamic-filter statistics, then click Send.
Shows how many connections were monitored with the Botnet
Traffic Filter, and how many of those connections match the
whitelist, blacklist, and graylist.
Tools > Command Line Interface
Type show running-config call-home, then click Send.
Shows the current Smart Call Home running configuration.
To Next Page
Loading...
Need help?
General
