CHAPTER
13-1
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
13
Configuring Objects
Objects are reusable components for use in your configuration. They can be defined and used in adaptive
security appliance configurations in the place of inline IP addresses. Objects make it easy to maintain
your configurations because you can modify an object in one place and have it be reflected in all other
places that are referencing it. Without objects you would have to modify the parameters for every feature
when required, instead of just once. For example, if a network object defines an IP address and subnet
mask, and you want to change the address, you only need to change it in the object definition, not in
every feature that refers to that IP address.
This chapter describes how to configure objects, and it includes the following sections:
• Configuring Network Objects and Groups, page 13-1
• Configuring Service Objects and Service Groups, page 13-5
• Configuring Regular Expressions, page 13-10
• Configuring Time Ranges, page 13-15
Note For other objects, see the following sections:
• Class Maps—See Chapter 36, “Getting Started With Application Layer Protocol Inspection.”
• Inspect Maps—See Chapter 36, “Getting Started With Application Layer Protocol Inspection.”
• TCP Maps—See the “Configuring Connection Settings” section on page 48-5.
Configuring Network Objects and Groups
This section describes how to use network objects and groups, and it includes the following topics:
• Network Object Overview, page 13-2
• Configuring a Network Object, page 13-2
• Configuring a Network Object Group, page 13-3
• Using Network Objects and Groups in a Rule, page 13-4
• Viewing the Usage of a Network Object or Group, page 13-4
To Next Page
Loading...
Need help?
General
