28-37
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 28 Configuring Twice NAT
Feature History for Twice NAT
Step 17 For the Translated Destination Address, type the name of the Original Destination Address
(TelnetWebServer) or click the browse button to choose it.
Because you do not want to translate the destination address, you need to configure identity NAT for it
by specifying the same address for the Original and Translated destination addresses.
Figure 28-83 Add NAT Rule Dialog Box: Completed
Step 18
Click OK to add the rule to the NAT table.
Step 19 Click Apply.
Feature History for Twice NAT
Table 28-1 lists each feature change and the platform release in which it was implemented. ASDM is
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 28-1 Feature History for Twice NAT
Feature Name
Platform
Releases Feature Information
Twice NAT 8.3(1) Twice NAT lets you identify both the source and destination
address in a single rule.
The following screen was modified: Configuration >
Firewall > NAT Rules.
To Next Page
Loading...
Need help?
General
