Cisco 7000 Hardware Installation And Maintenance

Index 1
Numerics
100BASE-FX 73
100BASE-T 73
100BASE-TX 73
10BaseT 91
16 Mbps LED on TRIP
See LEDs
16-bit CRC
See CRC 207
4 Mbps LED on TRIP
See LEDs
A
AC Power LED on power supply
See LEDs
AC power, input 25
acronyms, definition of 17
active monitor in Token Ring network 96
addresses, ports 54
agency approvals 21
AIP
cable connections 125
LEDs 268
microcode ROM replacement 166
air
cooling 21
dam 21
exhaust 63
filter
and environmental monitor 63
cleaning 237
flow 20, 26
AMD SuperNet chipset 44
ANSI X3.1 45
ANSI X3.1 standard 99
arbiter
replacing 246
arbiter board 246
arbiter, description of 21, 23
arbitration, CxBus 21
Asynchronous Tranfer Mode (ATM) Interface Processor
See AIP
attachment unit interface
See AUI
AUI
connector pinouts 250
EIP ports 42
autoreconfiguration in Token Ring network 96
auxiliary port 107
pinouts 250
auxiliary port, description 31
B
backplane
description 21
interface processor connections 158
slot keys 23
speed 20
back-up batteries 30
batteries, lithium backup 30
baud-rate settings 178
beaconing on ring network 96
blower
air flow path (illustration) 21
and environmental monitor 62
description 26
noise 152
replacing 242
boot command 170
Boot Error LED on RP
See LEDs
boot filenames 171
boot system flash command 148
boot-load failure 172
bootload-failure response 178
Break key (interrupt) 177
broadcast address destination, configuration register
settings 178
broadcast address, setting 172
burn in 151
bus
arbitration 21
CxBus 17
traffic control 23
bypass switch, optical for FDDI 98
C
CAB-ATM-DS3/E3 126
cable
MIP 102
cables
100BASE-T 73
AC power 25
attaching
FEIP 129
avoiding crossing 124
connecting external 124
console 84
console port 250
distance limitations 72
E1-G.703/G.704 104
Ethernet transceiver 250
Fast Ethernet specifications 73

Cisco 7000 Specifications

General

Product Type	Switch
Model	7000
Category	Switch
Ports	Varies by configuration
Power Supply	Redundant power supplies supported
Management	SNMP, CLI