Cisco ASR 9000 Series

2012::/64,
10.10.0.0/16,
10.2.0.0/24
end-set
route-policy pass-all
pass
end-policy
route-policy set_next_hop_agg_v4
set next-hop 10.0.0.1
end-policy
route-policy set_next_hop_static_v4
if (destination in static) then
set next-hop 10.1.0.1
else
drop
endif
end-policy
route-policy set_next_hop_agg_v6
set next-hop 2003::121
end-policy
route-policy set_next_hop_static_v6
if (destination in static) then
set next-hop 2011::121
else
drop
endif
end-policy
router bgp 65000
bgp fast-external-fallover disable
bgp confederation peers
65001
65002
bgp confederation identifier 1
bgp router-id 1.1.1.1
address-family ipv4 unicast
aggregate-address 10.2.0.0/24 route-policy set_next_hop_agg_v4
aggregate-address 10.3.0.0/24
redistribute static route-policy set_next_hop_static_v4
address-family ipv4 multicast
aggregate-address 10.2.0.0/24 route-policy set_next_hop_agg_v4
aggregate-address 10.3.0.0/24
redistribute static route-policy set_next_hop_static_v4
address-family ipv6 unicast
aggregate-address 2012::/64 route-policy set_next_hop_agg_v6
aggregate-address 2013::/64
redistribute static route-policy set_next_hop_static_v6
address-family ipv6 multicast
aggregate-address 2012::/64 route-policy set_next_hop_agg_v6
aggregate-address 2013::/64
redistribute static route-policy set_next_hop_static_v6
neighbor 10.0.101.60
remote-as 65000
address-family ipv4 unicast
address-family ipv4 multicast
neighbor 10.0.101.61
remote-as 65000
address-family ipv4 unicast
address-family ipv4 multicast
neighbor 10.0.101.62
remote-as 3
address-family ipv4 unicast
route-policy pass-all in
route-policy pass-all out
address-family ipv4 multicast
route-policy pass-all in
route-policy pass-all out
neighbor 10.0.101.64
remote-as 5
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
185
Implementing BGP
Enabling BGP: Example