A-4
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
AppendixA Error Messages for Security and QoS Configurations
%Error:Access Group is not supported on
EtherChannel interface
This error message means that an access group is applied on an
EtherChannel interface.
Access groups can be applied only to Layer 2 physical interfaces or
management VLANs.
%Error:A MAC Access Group exists on this
interface
This error means that a MAC access group was previously configured
on this interface.
Delete the MAC access group by using the no mac access-group
interface configuration command, and re-enter the ip access-group
interface configuration command.
%Error:An IP Access Group exists on this
interface
This error means that an IP access group was previously configured
on this interface.
Delete the IP access group by using the no ip access-group interface
configuration command, and re-enter the mac access-group interface
configuration command.
%Error:Out of Rule Resources
This error means that the hardware has run of resources.
Re-enter the command with fewer ACEs.
%Error:No free rules on this interface
This error means that the hardware has run out of resources.
Re-enter the command with fewer ACEs.
%Error:ASIC error
This error means that the hardware has returned an error and that the
command cannot be completed.
%Error:ASIC out of resources
This error message means that the hardware does not have sufficient
resources to support the user policies.
%Error:Mask/rule entry failure, errcode=XX
This error means that the hardware displays an unknown error with the
specified error code.
%Error:FAILURE to reinsert old ACL
This error means a hardware failure.
Delete the access group, and re-enter the command.
%Error:Max limit reached for number of ACEs in
The maximum limit for the number of ACEs in an ACL is reached.
The ACE can not be added to the ACL.
%Error:access-list too large to support on
this interface
The access list can not be applied on this interface because the
interface does not have sufficient resources to meet the requirement of
this access list. Re-enter the command with fewer ACEs.
%Error:FAILURE to reinsert old ACL, errcode=XX
This error means a hardware failure.
Delete the access group, and re-enter the command.
%Error:Egress port invalid
This error message means that an invalid egress port was detected by
the hardware. Re-enter the command for the interface.
%Error:The field sets of all the ACEs in an
ACL should match
All the ACEs in an ACL must have the same mask. Change the ACE
to have the same mask as the other ACEs in the ACL.
Table A-1 Common ACL Error Messages (continued)
Error Message Explanation and Suggested Solution
To Next Page
Loading...
