Cisco Catalyst 3750-E - Using Ftp to Access the Mib Files

A-4
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Appendix A Supported MIBs
Using FTP to Access the MIB Files
Using FTP to Access the MIB Files
You can get each MIB file by using this procedure:
Step 1 Make sure that your FTP client is in passive mode.
Note Some FTP clients do not support passive mode.
Step 2 Use FTP to access the server ftp.cisco.com.
Step 3 Log in with the username anonymous.
Step 4 Enter your e-mail username when prompted for the password.
Step 5 At the ftp> prompt, change directories to /pub/mibs/v1 and /pub/mibs/v2.
Step 6 Use the get MIB_filename command to obtain a copy of the MIB file.