Cisco Catalyst 3750-E - Configuring Basic Rip Parameters; Default Rip Configuration

40-21
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 40 Configuring IP Unicast Routing
Configuring RIP
Default RIP Configuration
Configuring Basic RIP Parameters
Note To configure RIP, you enable RIP routing for a network and optionally configure other parameters. On
the Catalyst 3750-E and 3560-E switches, RIP configuration commands are ignored until you configure
the network number.
Beginning in privileged EXEC mode, follow these steps to enable and configure RIP:
Ta b l e 40-4 Default RIP Configuration
Feature Default Setting
Auto summary Enabled.
Default-information originate Disabled.
Default metric Built-in; automatic metric translations.
IP RIP authentication key-chain No authentication.
Authentication mode: clear text.
IP RIP receive version According to the ver
sion router configuration command.
IP RIP send version According to the ver
sion router configuration command.
IP RIP triggered According to the ver
sion router configuration command.
IP split horizon Va ries wit h med ia .
Neighbor None defined.
Network None specified.
Offset list Disabled.
Output delay 0 milliseconds.
Timers basic
• Update: 30 seconds.
• Invalid: 180 seconds.
• Hold-down: 180 seconds.
• Flush: 240 seconds.
Validate-update-source Enabled.
Vers ion Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ip routing Enable IP routing. (Required only if IP routing is disabled.)
Step 3
router rip Enable a RIP routing process, and enter router configuration mode.