40-38
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 40 Configuring IP Unicast Routing
Configuring EIGRP
These sections contain this configuration information:
• Default EIGRP Configuration, page 40-38
• Configuring Basic EIGRP Parameters, page 40-40
• Configuring EIGRP Interfaces, page 40-41
• Configuring EIGRP Route Authentication, page 40-42
• EIGRP Stub Routing, page 40-43
• Monitoring and Maintaining EIGRP, page 40-44
Note To enable EIGRP, the switch or stack master must be running the IP services feature set.
Default EIGRP Configuration
Ta b l e 40-7 Default EIGRP Configuration
Feature Default Setting
Auto summary Enabled. Subprefixes are summarized to the classful network boundary when crossing
c
lassful network boundaries.
Default-information Exterior routes are accepted and default information is passed between EIGRP processes
w
hen doing redistribution.
Default metric Only connected routes and interface static routes can be redistributed without a default
m
etric. The metric includes:
• Bandwidth: 0 or greater kb/s.
• Delay (tens of microseconds): 0 or any positive number that is a multiple of 39.1
nanoseconds.
• Reliability: any number between 0 and 255 (255 means 100 percent reliability).
• Loading: effective bandwidth as a number between 0 and 255 (255 is 100 percent
loading).
• MTU: maximum transmission unit size of the route in bytes. 0 or any positive integer.
Distance Internal distance: 90.
External distance: 170.
EIGRP log-neighbor changes Disabled. No adjacency changes logged.
IP authentication key-chain No authentication provided.
IP authentication mode No authentication provided.
IP bandwidth-percent 50 percent.
IP hello interval For low-speed nonbroadcast multiaccess (NBMA) networks: 60 seconds; all other
ne
tworks: 5 seconds.
IP hold-time For low-speed NBMA networks: 180 seconds; all other networks: 15 seconds.
IP split-horizon Enabled.
IP summary address No summary aggregate addresses are predefined.
Metric weights tos: 0; k1 and k3: 1; k2, k4, and k5: 0