Cisco Catalyst 3750-E - Displaying Snmp Status

33-19
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 33 Configuring SNMP
Displaying SNMP Status
Displaying SNMP Status
To display SNMP input and output statistics, including the number of illegal community string entries,
errors, and requested variables, use the show snmp privileged EXEC command. You also can use the
other privileged EXEC commands in Table 33-6 to display SNMP information. For information about
the fields in the displays, see the C
isco IOS Configuration Fundamentals Command Reference.
Ta b l e 33-6 Commands for Displaying SNMP Information
Feature Default Setting
show snmp Displays SNMP statistics.
show snmp engineID [lo
cal | remote] Displays information on the local SNMP engine and all remote engines that have
been configured on the device.
show snmp group Displays information on each SNMP group on the network.
show snmp pending Displays information on pending SNMP requests.
show snmp sessions Displays information on the current SNMP sessions.
show snmp user Displays information on each SNMP user name in the SNMP users table.
Note You must use this command to display SNMPv3 configuration information
for auth | noauth | priv mode. This information is not displayed in the
show running-config output.