EasyManua.ls Logo

Cisco Catalyst 3750-E

Cisco Catalyst 3750-E
1414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER
32-1
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
32
Configuring System Message Logging
This chapter describes how to configure system message logging on the Catalyst 3750-E or 3560-E
switch. Unless otherwise noted, the term switch refers to a Catalyst 3750-E or 3560-E standalone switch
and to a Catalyst 3750-E switch stack.
Note For complete syntax and usage information for the commands used in this chapter, see the Cisco IOS
Configuration Fundamentals Command Reference, Release 12.2.
Understanding System Message Logging, page 32-1
Configuring System Message Logging, page 32-2
Displaying the Logging Configuration, page 32-14
Caution Logging messages to the console at a high rate can cause high CPU utilization and adversely affect how
the switch operates.
Understanding System Message Logging
By default, a switch sends the output from system messages and debug privileged EXEC commands to
a logging process. Stack members can trigger system messages. A stack member that generates a system
message appends its hostname in the form of hostname-n, where n is a switch number from 1 to 9, and
re
directs the output to the logging process on the stack master. Though the stack master is a stack
member, it does not append its hostname to system messages. The logging process controls the
distribution of logging messages to various destinations, such as the logging buffer, terminal lines, or a
UNIX syslog server, depending on your configuration. The process also sends messages to the console.
Note The syslog format is compatible with 4.3 BSD UNIX.
When the logging process is disabled, messages are sent only to the console. The messages are sent as
t
hey are generated, so message and debug output are interspersed with prompts or output from other
commands. On Catalyst 3750-E switches, messages appear on the active consoles after the process that
generated them has finished. On Catalyst 3560-E switches, messages appear on the console after the
process that generated them has finished.

Table of Contents

Other manuals for Cisco Catalyst 3750-E

Related product manuals