Cisco Catalyst 3750-E - Configuring Ethernet Interfaces; Tftp and the Ethernet Management Port

12-21
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 12 Configuring Interface Characteristics
Configuring Ethernet Interfaces
TFTP and the Ethernet Management Port
Use the commands in Table 12-2 when using TFTP to download or upload a configuration file to the boot
loader.
Configuring Ethernet Interfaces
These sections contain this configuration information:
• Default Ethernet Interface Configuration, page 12-22
• Configuring Interface Speed and Duplex Mode, page 12-23
• Configuring IEEE 802.3x Flow Control, page 12-25
• Configuring Auto-MDIX on an Interface, page 12-26
• Configuring a Power Management Mode on a PoE Port, page 12-27
• Budgeting Power for Devices Connected to a PoE Port, page 12-28
• Configuring Power Policing, page 12-30
• Adding a Description for an Interface, page 12-31
Ta b l e 12-2 Boot Loader Commands
Command Description
arp [i
p_address] Displays the currently cached ARP
1
table when this command is entered
without the i
p_address parameter.
Enables ARP to associate a MAC address with the specified IP address
w
hen this command is entered with the ip_address parameter.
1. ARP = Address Resolution Protocol.
mgmt_clr Clears the statistics for the Ethernet management port.
mgmt_init Starts the Ethernet management port.
mgmt_show Displays the statistics for the Ethernet management port.
ping ho
st_ip_address Sends ICMP ECHO_REQUEST packets to the specified network host.
boot tftp:
/file-url ... Loads and boots an executable image from the TFTP server and enters
the command-line interface.
For more details, see the command reference for this release.
copy t
ftp:/source-file-url
filesystem:/destination-file-
url
Copies a Cisco IOS image from the TFTP server to the specified
location.
For more details, see the command reference for this release.