Cisco Catalyst 3750-E

12-38
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 12 Configuring Interface Characteristics
Configuring the Power Supplies
To return to the RPS 2300 default settings, use these commands:
• To return to the default name setting (no name is configured), use the power rps switch-number port
rps-port-id name ““ user EXEC command with no space between the quotation marks.
• To return to the default port mode, use the power rps switch-number port rps-port-id active
command.
• To return to the default port priority, use the power rps switch-number port rps-port-id priority
command.
For more information about using the powe
r rps user EXEC command, see the command reference for
this release.
Configuring the Power Supplies
You can use the power supply user EXEC command to configure and manage the internal power supply
on the switch.
Step 2
power rps switch-number port rps-port-id mode {active |
standby}
Specify the mode of the RPS 2300 port.
The keywords have these meanings:
• switch-number—Specify the stack member to
which the RPS 2300 is connected. The range
is 1 to 9, depending on the switch member
nu
mbers in the stack. This keyword is supported
only on Catalyst 3750-E switches.
• port rps-port-id—Specify the RPS 2300 port.
The range is from 1 to 6.
• mode—Set the mode of the RPS 2300 port:
– active—The RPS 2300 can provide the
power to a switch when the switch internal
power supply cannot.
– standby—The RPS 2300 is not providing
power to a switch.
The default mode for RPS ports is ac
tive.
Step 3
power rps switch-number port rps-port-id priority priority Set the priority of the RPS 2300 port. The range is
from 1 to 6, where 1 is the highest priority and 6 is
the lowest priority.
The default port priority is 6.
Step 4
show env rps Verify your settings.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration
file.
Command Purpose