Cisco Catalyst 3750-E

12-41
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 12 Configuring Interface Characteristics
Monitoring and Maintaining the Interfaces
Clearing and Resetting Interfaces and Counters
Table 12-7 lists the privileged EXEC mode clear commands that you can use to clear counters and reset
interfaces.
To clear the interface counters shown by the s
how interfaces privileged EXEC command, use the clear
counters privileged EXEC command. The clear counters command clears all current interface counters
from the interface unless you specify optional arguments that clear only a specific interface type from a
specific interface number.
Note The clear counters privileged EXEC command does not clear counters retrieved by using Simple
Network Management Protocol (SNMP), but only those seen with the show interface privileged EXEC
command.
show interfaces transceiver properties (Optional) Display temperature, voltage, or amount of current on the
interface.
show interfaces [in
terface-id] [{transceiver
properties | detail}] module number]
Display physical and operational status about an SFP module.
show running-config interface [i
nterface-id] Display the running configuration in RAM for the interface.
show version Display the hardware configuration, software version, the names and
so
urces of configuration files, and the boot images.
show controllers ethernet-controller in
terface-id
phy
Display the operational state of the auto-MDIX feature on the
interface.
show power inline [in
terface-id | module
switch-number]
Display PoE status for a switch or switch stack, for an interface, or for
a specific switch in the stack.
show power inline consumption Display the power consumption data.
show power inline police Display the power policing data.
Table 12-6 Show Commands for Interfaces (continued)
Command Purpose
Ta b l e 12-7 Clear Commands for Interfaces
Command Purpose
clear counters [i
nterface-id] Clear interface counters.
clear interface in
terface-id Reset the hardware logic on an interface.
clear line [nu
mber | console 0 | vty number] Reset the hardware logic on an asynchronous serial line.