Cisco Catalyst 3750-E User Manual

28-9
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 28 Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring LLDP, LLDP-MED, and Wired Location Service
Use the no form of each command to return to the default setting.
This example shows how to configure VLAN 100 for voice application with CoS and to enable the
ne
twork-policy profile and network-policy TLV on an interface:
Switch# configure terminal
Switch(config)# network-policy profile 1
Switch(config-network-policy)# voice vlan 100 cos 4
Switch(config)# exit
Switch# configu
re terminal
Switch# interfa
ce_id
Switch(config-if)# network-policy profile 1
Switch(config-if)# lldp med-tlv-select network-policy
This example shows how to configure the voice application type for the native VLAN with priority
tagging:
Switch(config-network-policy)# voice vlan dot1p cos 4
Switch(config-network-policy)# voice vlan dot1p dscp 34
Configuring Location TLV and Wired Location Service
Beginning in privileged EXEC mode, follow these steps to configure location information for an
endpoint and to apply it to an interface.
Step 7
lldp med-tlv-select network-policy Specify the network-policy TLV.
Step 8
end Return to privileged EXEC mode.
Step 9
show network-policy profile Verify the configuration.
Step 10
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
location {admin-tag string | civic-location
identifier id | elin-location string identifier
id}
Specify the location information for an endpoint.
• admin-tag—Specify an administrative tag or site information.
• civic-location—Specify civic location information.
• elin-location—Specify emergency location information (ELIN).
• identifier id—Specify the ID for the civic location.
• string—Specify the site or location information in alphanumeric
format.
Step 3
exit Return to global configuration mode.
Step 4
interface interface-id Specify the interface on which you are configuring the location
information, and enter interface configuration mode.

Cisco Catalyst 3750-E Specifications

General

Series	Catalyst 3750-E
Switching Capacity	32 Gbps
Stacking Bandwidth	32 Gbps
StackWise Plus	Yes
Layer Support	Layer 3
MAC Address Table Size	12, 000 entries
RAM	256 MB
Flash Memory	64 MB
Memory	256 MB DRAM, 64 MB Flash
Operating Temperature	32 to 113°F (0 to 45°C)
Ports	48 10/100/1000 Ethernet ports
Form Factor	Rack-mountable
Jumbo Frame Support	Yes
Input Voltage	100 to 240 VAC
Storage Temperature	-25 to 70 °C
Relative Humidity	10 to 90% non-condensing