Cisco Catalyst 3750-E - Page 1309

B-7
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
Working with the Flash File System
Beginning in privileged EXEC mode, follow these steps to create a file, display the contents, and extract
it.
Command Purpose
Step 1
archive /create destination-url
flash:/file-url
Create a file and add files to it.
For de
stination-url, specify the destination URL alias for the local or network
file system and the name of the file to create. The -filename. is the file to be
created. These options are supported:
• Local flash file system syntax:
flash:
• FTP syntax:
ftp:[[//use
rname[:password]@location]/directory]/-filename.
• RCP syntax:
rcp:[[//use
rname@location]/directory]/-filename.
• TFTP syntax:
tftp:[[//lo
cation]/directory]/-filename.
For fl
ash:/file-url, specify the location on the local flash file system in which
the new file is created. You can also specify an optional list of files or directories
within the source directory to add to the new file. If none are specified, all files
and directories at this level are written to the newly created file.
Step 2
archive /table source-url Display the contents of a file.
For sou
rce-url, specify the source URL alias for the local or network file
system. The -filename. is the file to display. These options are supported:
• Local flash file system syntax:
flash:
• FTP syntax:
ftp:[[//use
rname[:password]@location]/directory]/-filename.
• RCP syntax:
rcp:[[//use
rname@location]/directory]/-filename.
• TFTP syntax:
tftp:[[//lo
cation]/directory]/-filename.
You can also limit the file displays by specifying a list of files or directories after
th
e file. Only those files appear. If none are specified, all files and directories
appear.