Cisco Catalyst 3750-E - Page 1406

Index
IN-50
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
UplinkFast
described 20-3
enabling 20-15
VLAN-bridge 18-11
stratum, NTP 7-2
stub areas, OSPF 40-32
stub routing, EIGRP 40-43
subdomains, private VLAN 16-1
subnet mask 40-7
subnet zero 40-7
success response, VMPS 13-26
summer time 7-13
SunNet Manager 1-6
supernet 40-8
supported port-based authentication methods 10-8
SVI autostate exclude
configuring
12-33
defined 12-6
SVI link state 12-6
SVIs
and IP unicast routing
40-5
and router ACLs 35-4
connecting VLANs 12-11
defined 12-5
routing between VLANs 13-2
switch 41-2
switch clustering technology 6-1
See also clusters, switch
switch console port
1-7
Switch Database Management
See SDM
switched packets, ACLs on
35-39
Switched Port Analyzer
See SPAN
switched ports
12-2
switchport backup interface 21-4, 21-5
switchport block multicast command 26-8
switchport block unicast command 26-8
switchport command 12-22
switchport mode dot1q-tunnel command 17-7
switchport protected command 26-7
switch priority
MSTP
19-22
STP 18-21
switch software features 1-1
switch virtual interface
See SVI
synchronization, BGP
40-49
syslog
See system message logging
system capabilities TLV
28-2
system clock
configuring
daylight saving time
7-13
manually 7-11
summer time 7-13
time zones 7-12
displaying the time and date 7-12
overview 7-2
See also NTP
system description TLV
28-2
system message logging
default configuration
32-4
defining error message severity levels 32-9
disabling 32-4
displaying the configuration 32-14
enabling 32-5
facility keywords, described 32-14
level keywords, described 32-10
limiting messages 32-10
message format 32-2
overview 32-1
sequence numbers, enabling and disabling 32-8
setting the display destination device 32-5
stack changes, effects of 32-2
synchronizing log messages 32-6
syslog facility 1-16
time stamps, enabling and disabling 32-8