Cisco Catalyst 3750-E - Page 33

Contents
xxxiii
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Configuring Layer 2 EtherChannels 38-13
Configuring Layer 3 EtherChannels 38-15
Creating Port-Channel Logical Interfaces 38-15
Configuring the Physical Interfaces 38-16
Configuring EtherChannel Load-Balancing 38-18
Configuring the PAgP Learn Method and Priority 38-19
Configuring LACP Hot-Standby Ports 38-20
Configuring the LACP System Priority 38-21
Configuring the LACP Port Priority 38-22
Displaying EtherChannel, PAgP, and LACP Status 38-22
Understanding Link-State Tracking 38-23
Configuring Link-State Tracking 38-25
Default Link-State Tracking Configuration 38-26
Link-State Tracking Configuration Guidelines 38-26
Configuring Link-State Tracking 38-26
Displaying Link-State Tracking Status 38-27
CHAPTER 39 Configuring TelePresence E911 IP Phone Support 39-1
Understanding TelePresence E911 IP Phone Support 39-1
Configuring TelePresence E911 IP Phone Support 39-2
Configuration Guidelines 39-2
Enabling TelePresence E911 IP Phone Support 39-3
Example 39-3
CHAPTER 40 Configuring IP Unicast Routing 40-1
Understanding IP Routing 40-2
Types of Routing 40-2
IP Routing and Switch Stacks 40-3
Steps for Configuring Routing 40-5
Configuring IP Addressing 40-5
Default Addressing Configuration 40-6
Assigning IP Addresses to Network Interfaces 40-7
Use of Subnet Zero 40-7
Classless Routing 40-8
Configuring Address Resolution Methods 40-9
Define a Static ARP Cache 40-10
Set ARP Encapsulation 40-11
Enable Proxy ARP 40-12
Routing Assistance When IP Routing is Disabled 40-12